Wedge

Wedge is a great climb located on the open slab between Sliding Board and Sea of Holes. The route offers some great slab climbing as well as some low angle face climbing. The route protects well but be ready for a couple of your typical Whitehorse run outs.[Admin's COMMENT 2015 - The first 2-3 pitches described by the original submitter of this route are those described in the old (1996) Handren guide as the alternate start for Wedge. They are further right than the FA route. I've chosen to put the FA route first, the alternate is given second.] "Route of FA":P1- START Looking up from the base there are two tree islands left of the base of the Arch. The first tree island is about 40 ft left of the base of the arch, or about 25 ft left of the bolts of Sliding Board. Wedge starts at the second tree island, about 40+/- ft further left.The FA party climbed directly up from the base to this left-most of the two "bushes & tree ledge", probably in two pitches. (Those were the days of 150 ft-or-shorter-ropes, and sneakers, which were used on the FA.) Today you can just about make it with a 70m rope in one pitch, although the second will have to simul-climb up 20-25 ft for the leader to reach the tree. There is a small overlap(gear) part way up which might serve as a belay.P1- The more modern way starts from the Launching Pad on Std Route. Go up and left, passing one bolt in the "sea of slab". (NOTE - This bolt is hard to see. It is located directly below the right end of the right-tree-island, about as far below the end of the island as the island is long. )  From the bolt (possible belay) continue traversing nearly horizontally to the left tree island.  The second might have to simul-climb up a little way, although a 70m might make it.  220+ ft  5.3 RP2- Up the flake, ( good gear in a “hole” just above) then up the slab to a double bolt anchor. 140 ft 5.5

R, although if you move a bit right  there's a bolt you can clip on the way. Use a long sling and move back left. ( This single bolt seems to have been ”converted” to a double bolt anchor. R Hall 10/1/31) P3- Move up and right from the anchor, passing a recently-replaced bolt. [If you follow this you don't "climb to the overlap and clip the rusty pin".] Gear belay at the ancient ring piton at the "small tree ledge." 70 ft 5.5-5.6  The original ("boltless") ascent probably went directly up to the steep overlap and then traversed horizontally.

[P3 be combined with P2 with a 70m rope, or a "long" 60m ; or, P4 may be combined with P3...but not both!]P4- Up the obvious corner system(s) to the crux (new-ish bolt, up high and left). Above the balancy-crux, continue up a few more feet, then traverse right to a comfortable ledge and new bolted anchor. Be sure to have the follower(s) protected on the crux. 80-90 ft, 5.6-5.7 P5- Up the inside corner system that is just left of the belay. A wonderful pitch, with many “mini-variations” ( in other words, finding the easiest route might be interesting) End at a pine tree with slings. 90-100 ft 5.6, 5.6+ ? A brush is sometimes handy here as pine needles collect on the holds.

[ This is a candidate for a dbl bolt anchor. Someone has “ backed up” the 8-10 inch diameter tree with cord to a 3-4 inch tree. Ha! Sort of like tieing an 18-wheeler to a Volkswagen Beetle to keep the 18-wheeler from falling off a cliff! ] As said above, most will chose to end here and rap (or lower off: it's less than 1/2 a rope length for 60m ropes) back down to the dblt bolt anchor at the end of P4. A series of double rope raps will get you back to the Launching Pad.  There is a way to do this with a single 70m, but you need to work this out yourself.To join Sliding Board, from the bolted belay at the end of P4 move up and right diagonally across the slab below the large overlap. Go around its end to a 2 or 3 inch ledge and an old pin easily backed up with med-large Cams. 100 ft 5.3-5.4 PG-13 /R for both leader and follower You are now on Sliding Board at the belay below the run-out slab that leads to the dbl bolt anchor just below the "headwall" broken by an obvious dike.P6, 7, 8 etc. of Wedge - To maintain the 5.6 grade, move up and left on the big tree ledge and find the groove (sort of a "V" chimney) where Dike Route climbs through the big overlap.  There used to be an ancient piton.  Above this wind you way up the slabs to the top, intercepting Standard Route. Be extra careful of rocks just laying on slab in these final 2-3 pitches !!! There are probably climbers below ! Alternate Route - P1. Same as "the more modern way" described above. ( from the Launching Pad on Std Route go up and left, passing one bolt in the "sea of slab" to the left-most tree island.) .P2. Climb straight up the blank slab passing a two-bolt anchor [the dbl bolt anchor of the "FA Wedge"] and a single protection bolt. When you reach the headwall, clip the old rusty piton and traverse right to a comfortable ledge. You can make a 3-point anchor using the rusty piton, a nut and a small cam. [NOTEs- You reach the pin (if its still there) by climbing left of the bolt. Many climb up right of the bolt. Note that you have combined P2 and P3 of the FA Route.]P3. (Same as P4 above) From the anchor, head up the slab and climb the nice lay back crack. At the top of the crack, clip a bolt and make thin moves up and right to gain a nice ledge with a two-bolt anchor. Do not forget to protect your partner on the traverse to the belay ledge.P4. (Same as pitch 5 above) Climb straight up to a large pine tree used to rap the route. If you use the fixed gear on this pitch, be sure to use long runners, as you will generate a lot of rope drag if you don’t.[ note, there is no longer any fixed gear on this pitch ( and hasn’t been for a few years) 10/2/21 R Hall, Admin] P5. (Same as P6 above) If you choose to top out, climb up and left of the pine tree to a large ledge. Traverse the ledge until you reach a corner with some old pitons in it. Climb the corner to the tree ledge above.Note: The rock will have a lot of lichen on it so be very cautious as you climb the corner to the tree ledge.P6. (Same as P7,8 etc above) To reach the top, find the path of least resistance keeping in mind that you will want to head up and to the right. Stay roped together and protect yourself and partner by slinging trees and or placing gear as you make you way to the top. It is all scrambling/simo-climbing so take your time and be very cautious, there are lots of LARGE rocks just laying on the slab(s) and it is often the rope, not the climber, that may dislodge them!

From the starting ledge, look for a clump of bushes up and to your left.

2 60-meter ropes 1 Set of Stoppers 1 Set up Cams to a #2 Camalot 4 Quick Draws 5 2ft Slings 1 Cordellette

Extra webbing if you need to replace any when rappelling the route.